door signalers | smoke/fire | carbon monoxide | telephone signalers | pagers
Door Knock Signaler
Flashes light with knock on door.....picture
Features:
Senses door knock vibration
Flash of extra bright light responds for several seconds
Sensitivity switch ensures maximum results
Use at home or away
Simple to install.
Uses 9 volt battery (not included)
Permanently install with a screw, attach to door with velcro or use hanging bracket included.
Part # CT-DKS3LED...$29.00
Wireless Strobe and Door Chime.....picture
Features: Wireless - simply plug in
Suitable for the hard of hearing or use in noisy environments
Use in the home, office, factory
White receiver and one button. Just plug receiver into a convenient wall outlet
and it's ready for use.
Up to three door operation with addition of LA207TWH buttons.
Receiver 3-1/4" wide x 4-1/2" high x 1-1/2" deep
Part # NT-LA204WH ...$79.00
Additional Buttons
Part # NT-LA207TWH ...$15.00
Additional Receivers may be used in other locations.
If you need a chime in the basement or upstairs, add another receiver where
you can't hear.
Part # NT-LA204RWH ...$65.00
AM100 Door and Telephone Signaler.... picture
Economical alerting for phone and doorbell only. Flashes a lamp that is
plugged into the receiver unit to alert you to the phone or doorbell ringing.
Mount the doorbell button (included) outside the door. No wiring necessary. Plug
the line cord into a phone jack. When the doorbell is pressed or the phone
rings, your lamp plugged into the master will flash and the appropriate icon
will light up. One year warranty.
Part # AP-AM100...$79.00
Extend-A-Chime...picture
For use with an existing doorbell.
Wireless doorbell chime works with your existing doorbell to put the chime sound
where you can hear it best. Comes with a transmitter and a remote chime
receiver. Wire the transmitter box to the low-voltage terminals on your doorbell
chime box. Plug the remote chime receiver into an AC outlet in the room where
you need to hear the sound. When your doorbell is pressed, the trransmitter send
a signal to the receiver and the low frequency chime sounds in that location. No
batteries needed. Use as many receivers as necessary. Five year warranty.
Part # DM-RC3030...$33.30
Additional Remote Chime Receivers
Part # DM-RC3733...$29.00
Silent Call Shake Up Wireless Smoke Detector System.....picture
Mount the battery powered smoke detector transmitter anywhere in your home. Place the receiver in the location you want to be alerted, next to the bed, in the living room, etc. The transmitter detects smoke within a radius of 100’, and sends a signal that turns on a vibrator or flashes a strobe connected to the receiver. Easy installation, no wiring necessary. Use as many smoke detectors and receivers as you wish. Completely portable. Transmitter uses 9 volt battery (included). Two year warranty.
Shake-up with vibrator receiver
Part # SC-SU-12V..... $273.00
Shake-up with Sidekick strobe receiver
This receiver will signal in response to other Silent Call
transmitters (door, phone, sound monitor, carbon monoxide detector, etc.)
as well as the smoke detector.
Part # SC-SU-24SK.... $295.00
Additional receiver with vibrator
Part # SC-SU5001-V..... $154.00
Additional receiver with strobe
Part # SC-SU5001-S .....$175.00
Additional smoke detector transmitter
Part # SC-1008-2..... $109.00
Vibrator to use with SideKick
Fire Alarm Transmitter
Adding Shake-up Receivers to an existing hardwired smoke detector
is possible if the smoke detectors have a Form C dry contact relay. A
transmitter can be wired to the home or building fire alarm system. This
transmitter should be installed by a licensed fire alarm company. In the event
of a fire, the transmitter will signal the receiver triggering the strobe or
vibrator. Call HARC for details.
Part # SC-FA1004..... $69.25
Gentex Portable Smoke Detector W/Strobe.....picture
Features:
Dual alarm system provides an effective warning
Loud horn (90dB) and bright strobe (177+ candela) for ADA compliance
Photoelectric detection senses fire early
Portable, Plugs into any standard 120 volt outlet
Battery backup for audible horn only
Meets all state codes and requirements of NFPA-72G
Part # GT-7109LS...$165.00
Same as above only hardwired installation
With switch leg available to turn on auxiliary device
Should be installed by electrician
Part # GT-7109CS...$149.00
Portable detector without battery backup
Part # GT-710LS $159.00
Hardwired detector without battery backup
Part # GT-710CS $129.00
Wheelock Phone Strobe
Flashes light when phone rings.....picture
Features:
Provides visual signal when phone is difficult to hear
Bright strobe flashes when phone rings
Ideal for home, shop or high noise area where bells can't be heard
High commercial quality
Wall mount, plugs into AC outlet and RJ11C phone jack
White with black letters. Size 4.75"H x 2.5"W x 3" D
Part # WH-PS11AWPW...$79.00
Ameriphone Super Phone Ringer
Generates ring up to 95dB+.....picture
Features:
Adjustable ring tone and volume controls
Four selectable ring patterns
Bright visual ring flasher
Dual modular phone jack
AC adapter included, battery backup
One year warranty
Part # AP-SR200...$49.00
Super Phone Ringer without Strobe
Part # AP-SR100...36.00
Sonic Alert Phone Flasher
Sonic Ring Jr. Telephone ring signaler.....picture
Features:
Upon plugging lamp into signaler, lamp will flash when phone rings
Plugs into modular jack and electrical outlet
Installs easily
7' cord accommodates variety of lamp and phone locations
Does NOT use remote receivers
Part # SA-TR50...$24.00
Vibrating Personal Pager
.....pictureFlash Call -
same as above but receiver has strobe not vibrator.
HARC Mercantile Ltd.
Phone 800-445-9968